Just found out the old '3 dots' test is fake and my emulsion runs got way cleaner
I was poking around a screen printing forum last week and stumbled on a post from a guy in Ohio saying the whole "count the dots" test to check your mesh count is basically garbage, and I was kind of annoyed because I had been eyeballing my frames that way for about 8 months. Turns out the mesh on cheap hobby frames varies so much that counting holes in a square inch gets you nowhere, and the real way is just to hold the frame up to a light and see how much squeegee pressure you need to push ink through. I tested it on 3 of my frames that night, and two of them were way tighter than I thought, which explains why my last batch of shirts had that faded look at the edges. Since then I switched my exposure time from 6 minutes to 8 on those frames and my stencils are holding way better. I'm printing a small run of 20 shirts for a buddy's bike shop in Sacramento this weekend and I'm actually not dreading the washout. Any of you run a light table or do you just eyeball it like I used to?