That time a senior drafter showed me my lineweights were off by just 0.2mm

I was working on a big HVAC layout for a school project in Denver, and an older guy named Roy came over to check my prints. He pointed at a supply duct and said, "Your supply lines are the same thickness as your return lines, that's confusing the whole thing." He was right, I had been rushing and didn't notice. Has anyone else had a small detail like that completely mess up a drawing?

2 comments

2 Comments

paul_mason126d ago

Fair enough, but I've seen plenty of good drawings where lineweights barely matter.

saraho486d ago

@paul_mason12 Bad drawings can still sell with thick lines, yeah. But thin ones make or break it.